I am very sorry, but I am unable to make it to NAMM after all.
There is just too much to do right now, but please stop by and visit the following folks: Shawn of Analog Haven, Harvestman, and Malekko. They will have some great setups to check out.
Currently working on: Infernal Noise Machine build
In progress: Sound of Shadows delay module initial production run
Babble: I am proceeding a bit slowerr than usual right now. Aside from the standard SNAFUS, we have not only the joyous *cough* holiday season, with all of the attendant problems/interruptions, but I also lost an argument with a piece of aluminum this weekend and had to get some stitches.
Nothing serious – a ~2cm gash, just below my right thumb and above the wrist, but enough to slow me down (yes, even more). Please feel free to contact me if you have any questions regarding order completion times or anything else.
~flight
Just FYI.
Currently working on a batch of Infernal Noise Machines.
Sound of Shadows production has begun.
Going to bed now.
~flight
posted by flight at 10:01 AM
Yeah, stupid busy again. The last of the group-buy jacks go out tomorrow. Quad Plague Bearers next, then the INM. Please let me know if you have any questions! Don’t hesitate to write, seriously. I’m not as fast in responding as I used to be, but that’s because I try to stay focused on getting orders out. I still try to respond to urgent messages within a couple hours.
I’ll try to keep this updated with the major production stages.
posted by flight at 10:37 PM
The Infernal Noise Machines are finally out the door! Damn.
Anyway, on to the desktop Quad PBs.
posted by flight at 5:14 AM
The INM are in the final stretch. All boards are assembled, all the VCO were tested and calibrated yesterday, all the PSU are tested. Assembly of the main boards was finished today, and I’m about halfway done with the wire harnesses. Tomorrow is completion of the wire harnesses, and the testing and calibration of the main boards.
I’m trying to keep away from any distractions right now so I’m avoiding being online as much as possible. Please bear with me if it takes a bit for me to respond to emails – service issues, however, will be handle as quickly as possible.
~flight
posted by flight at 10:42 PM
Yup, still working on the INM. I figured it would be a good idea to show some proof of some kind, so here’s a picture of the boards laid out on my bench.
There’s a few more that aren’t in the picture, but you get the point.
I apologize for my slow response to emails lately, but I’m focusing on getting these out!
posted by flight at 11:04 PM
I’m building all the remaining unit concurrently, I’ll post news when I have some. I hope to be finished with these this weekend/early next week.
I still have a few sets of PCBs remaining if anyone is interested. USD$666.00 + S&H.
Lead time 8-12 weeks, as I still have to finish the Quad Plague Bearers and get going on a few other things.
posted by flight at 7:12 PM
Alrighty! It’s INM time. The new fiberglass-cutting router bits came in, the table is cleared except for the Standalone Quad PBs (for which the panels are on their way, and I have enough enclosures for 5 more if anyone else wants some, $350 each, r 3.2 with VC gain. Production begins as soon as the INM are finished).
posted by flight at 9:42 PM